Skip to content
  1. Feb 12, 2014
  2. Feb 11, 2014
  3. Feb 09, 2014
  4. Feb 07, 2014
  5. Feb 05, 2014
  6. Feb 03, 2014
    • ErikZalm's avatar
      Merge pull request #743 from Opticalworm/Marlin_v1 · e1ae7952
      ErikZalm authored
      Improved support for panelolu2 encoder and buzzer
      e1ae7952
    • ErikZalm's avatar
      Merge pull request #744 from drf5n/watts · 1cc9212c
      ErikZalm authored
      Heater wattage reporting for M105 using EXTRUDER_WATTS and BED_WATTS
      1cc9212c
    • David Forrest's avatar
    • Ronald's avatar
      Changed 1284p fuse setting for Arduino_1.x.x · c2b3e887
      Ronald authored
      - Remove the two version of 16mHz. Crystal and resonator use the same
      fuse setting. Also, Arduino IDE only showed the first one 16Mhz as a
      board option.
      
      - Added 20Mhz board option.
      
      Symptoms for incorrect fuse setting:
      - X axis move in one direction
      - limit switches fail to trigger
      - unable to reprogram the device via bootloader
      - stops working when the reset switch is pressed.
      - device fails to bootup when power by a slow raise power supply.
      
      Solution:
      - Disabled the jtag
      - set the correct clock selection bit
      - set the correct bootloader memory size
      - enable brown-out setting
      - enable clock power up delay
      c2b3e887
    • Ronald's avatar
      Improved support for panelolu2 encoder and buzzer · 8d162e5b
      Ronald authored
      I added #define for LCD_FEEDBACK_FREQUENCY_HZ and
      LCD_FEEDBACK_FREQUENCY_DURATION_MS  which is used to alter the default
      buzzer sound.
      
      When selecting Panelolu2 in configuration.h:
      - it automatically sets the correct ENCODER_PULSES_PER_STEP and
      ENCODER_STEPS_PER_MENU_ITEM.
      - if LCD_USE_I2C_BUZZER is defined it will also set the default
      LCD_FEEDBACK_FREQUENCY_HZ and LCD_FEEDBACK_FREQUENCY_DURATION_MS
      
      When selecting the sanguinololu 1284p the following is true:
      - its now enables  LARGE_FLASH
      - It enables the gcode M300 when the panelolu2 LCD_USE_I2C_BUZZER is
      defined
      8d162e5b
  7. Feb 02, 2014
  8. Feb 01, 2014
  9. Jan 31, 2014
  10. Jan 30, 2014