- Dec 22, 2011
-
-
Bernhard authored
-
Bernhard authored
arduino-0023/hardware/arduino/cores/arduino/wiring.h this is necessary if the avr libraries are recent, but arduino is old. Alternative: newer arduino
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
advance and ultipanel not any more in default config
-
-
Bernhard authored
-
- Dec 15, 2011
-
-
Erik van der Zalm authored
-
- Dec 12, 2011
-
-
Erik van der Zalm authored
-
Erik van der Zalm authored
-
Erik van der Zalm authored
Soft PWM. (Sanguinololu can also have PID temperature control) Interrupt save WRITE for addresses > 0x0FF
-
- Dec 11, 2011
- Dec 09, 2011
-
-
Bernhard authored
heating up santity, formarly knows as "watchdog", but renamed due to the existance of the real watchdog, works now.
-
Bernhard authored
-
Bernhard Kubicek authored
Fix M201 not saving settings in all places, so the changes did not get written into EEPROM
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
added a partial release option to "m84" aka "stepper release". If you do tiny layers, you might want to keep the z-axis powered to not loose height positioning after homeing.
-
Bernhard authored
-
Bernhard authored
fixed the st_synchronize. it would have continued if there is only the last move of the buffer being stepped.
-
- Dec 08, 2011
-
-
Keegi authored
-
- Dec 07, 2011
-
-
Bernhard authored
-
Bernhard authored
-
Bernhard authored
-
-
Erik van der Zalm authored
-
- Dec 06, 2011
-
-
Denis B authored
- The temperature control is pretty much complete (not sure what to do w/ autotemp though) Changed the pins assignment to clearly separate bed and extruder heaters and temp sensors, changed a bit how termistor tables are handled. - The steppers control is rudimentary (only chanages what pins it uses depending on the active_extruder var, but that's enough for switching extruder in the start.gcode in the the profiles) - Tested only w/ RAMPS 1.4
-
- Dec 04, 2011
-
-
-
Bernhard authored
added M503 to display eeprom storage, and renamed eeprom routings. This version is compatible with the qtmarlin eeprom-tab.
-
Erik van der Zalm authored
-
Erik van der Zalm authored
-