Separate PID_MAX from BANG_MAX

HTML removed, Rumba added

This allows PID_FUNCTIONAL_RANGE to use a maximum duty cycle higher
than PID_MAX. This is useful for powerful heaters to heat quickly in
bang-bang mode, but use a lower duty cycle that is easier to stabilize
in PID mode.

Found some unwanted html at the bottom of the file which caused it to not be able to compile.
Also added rumba as machine.

Adding Maker's Tool Works heated bed thermistor

Add STB board support to Marlin (next step towards graphic LCD implementation)

Fix step rate bug (especially for retraction)

These definition contain also the definition for the graphics LCD.

Definition for the graphic LCD are already in it, they will not harm the
configuration as they are only defined constants

Marlin with ATmega1284p sanguino support under Arduino 023

Added the optiboot bootloader, uses only 512kB of FLASH
Includes .hex file is for 20MHz µC Clock and serial speed of 57k6

This is the actual Sanguino release for Arduino 023.
It has full ATmega1284p support.

Reference:
https://code.google.com/p/sanguino/downloads/detail?name=Sanguino-0023r4.zip&can=2&q=

ATmega644P 16MHz, ATmega1284p 8, 16, 20MHz

Hotend offset handling for multi-extruder machines

Conflicts:
	Marlin/language.h
	Marlin/thermistortables.h

Marlin v1, alignment of the Italian language

Update Marlin/language.h

Update Polish language 	#define MSG_RESUMING "Wznawiam drukowanie"

Add SD-Card change and SD-Card init. for electronics equipped with LCD Display

Update Marlin/ultralcd_implementation_hitachi_HD44780.h

Fix to a bug that I just introduced - sorry. Forgot about offset of string length.

Add SD-Card change and SD-Card init. for reprap electronics without
SD-Chard change detect pin.

Update Marlin/ultralcd_implementation_hitachi_HD44780.h

Use all available characters in narrow LCDs < 20 characters.

Fix to a minor bug with hardcoded LCD_WIDTH that draws edited values outside of the 16 characters width LCDs.

The extruder offset can be specified in the configuration
file or adjusted on the fly using the "M218 T# X# Y#" command.
The EEPROM support is not yet merged in.
The "T#" command can take option "F#" that specifies the feedrate
at which the printing head should be re-positioned. If not
specified the re-positioning move is not preformed immediately,
but the coordinates are adjusted for the printer to properly
position the head when the next movement happens.

Also skip .files and _files with long filenames. I think its better than before. If somebody dislikes it, or wants additional configuration, it can be done in a future step. Thanks, Marius, and nice to have you helping!