Default off.

Needs some work to remove the blocking in read max6675.

Added late z enable. (blddk request)
Only calculate look ahead if >2 moves in buffer.
Removed some FORCE_INLINE to save memory.

Signed-off-by: Erik van der Zalm <erik@vdzalm.eu>

M109 EOL fix when TEMP_RESIDENCY_TIME is undefined; printer interface (p...

M109 EOL fix when TEMP_RESIDENCY_TIME is undefined; printer interface (pronterface) could not see target extruder heater temperature to continue print

added suicide pin for a power supply to the arduino that is only active if the arduino is holding high for an output.

 arduino-0023/hardware/arduino/cores/arduino/wiring.h
this is necessary if the avr libraries are recent, but arduino is old. Alternative: newer arduino

advance and ultipanel not any more in default config

This reverts commit 651cde8b.

Soft PWM. (Sanguinololu can also have PID temperature control)
Interrupt save WRITE for addresses > 0x0FF

heating up santity, formarly knows as "watchdog", but renamed due to the existance of the real watchdog, works now.

Fix M201 not saving settings in all places, so the changes did not get written into EEPROM