TX timeout must also be cancelled on a TX error.  TX timeout should check if we are waiting for a TXto complete.  TX timeout was too short (short than the maximum number of retries).

Spirit network driver:  TX timeout was never being cancelled!  Also reviewed and cleaned up all error handling logic

6LoWPAN:  When obtaining the radio MAC address from the IP address, handle the special case of broadcast and multicast address.

STM32F103-Minimum: (1) Enable CONFIG_MTD_PARTITION in Kconfig if flash partition is enabled and (2) Update the README.txt file with info needed to get SmartFS working.

Spirit:  Restore the 96 byte maximum packet length.  Reducing the packet length had no effect on eliminating RX FIFO errors.

Spirit Network Driver:  Add support for watermark interrupts on RX FIFO.  Reduce max packet length to avoid an errata.

IEEE 802.15.4 network drivr:  Fix more compile issues that only show up when CONFIG_NET_STARPOINT is defined.

IEEE 802.15.4 network driver:  Fix some errors introduced in previous commit.  Clean up some of the casting logic.

Spirit + 6LoWPAN:  In STAR configuration, Spirit must use a configured well known hub address.  6LoWPAN cannot assume that the PAN coordinator is the STAR hub; it must ask the radio to provide it with the address of the star hub

B-L475E-IOT01A: Make spirit-6lowpan configuration match what is currently under test:  Enable multicast, broadcast, but disable CRC support.  Currently CRCs are not working right.

Spirit: Increase number of retries if there is no acknowledgement; Add interrupt handling for the case where the max number of retries expires.  Fix some badly implemented queue management code.  With these changes the basic UDP and TCP tests work.

Spirit:  Convert network driver to use STack packets vs. Basic packets.  We need to use the STack packets in order to provide the source address.

Spirit: Correct setting of the length width field; Add multicast and broadcast addresses to radio properities.

Spirit network driver:  Need to enable sending of TX address.  Moved some non-optional settings out of board.h to driver.

RAMTRON:  Should be able to select chunked write mode via a configuration option, not by editing the file.

RAMTRON: Add support for splitting block writes in chunks.  Some Re-RAMs like MB85AS4MT has a write buffer size limitation.

drivers: handle I2C_TRANSFER return value consistently.  Some I2C peripherals transfers return zero on success, others number of completed transfers. Make drivers robust against this.

spirit:  Modify reg needs to toggle CS to get the correct status.  Remove some delbug left in last commit.  make sprit_unlock an inline function.