LPC17xx:  Add IPv6 support to the LPC17 Ethernet driver.  Untested... I no longer have a proper environment for LPC17 debug.

SAM4 Ethernet Driver:  No supports operation using the high priority work queue so that packet processing can occur outside of interrupt level processing.

SAM4E-EK: The nsh configuration now configures the Ethernet driver for execution on the HP work thread.

Big, very risky change:  Remove all occurrences of up_maskack_irq() that disable and enable interrupts with up_ack_irq() that only acknowledges the interrupts.  This is only used in interrupt decoding logic.  Also remove the logic that unconditionally re-enables interrupts with the interrupt exits.  This interferes with the drivers ability to control the interrupt state.  This is a necessary, sweeping, global change and unfortunately impossible to test.

SAMA5D Ethernet:  Add support for CONFIG_NET_NOTINTS so that the driver can operate from the work queue thread instead of doing everything from the interrupt level.

ARMv7-A interrupt handler:  Should not automatically re-enable interrupts on interrupt return.  That interferes with the driver's ability to manage interrupts.

Add logic so that STM32 Ethernet drivier can avoid interrupt level processing and, instead, execute on the work thread.

SYSLOG: Add an option to use the syslog'ing device as the system consolution.  This option enables a low-level, write-only console device at /dev/console (similar to the low-level UART console device).  From Pierre-noel Bouteville.

STM32 SPI:  The source clock for SPI 4,5, and 6 should be PCLK2, not PCLK1 (for F411, F427, and F429).  Per David Sidrane.

STM32: Add an IPv6 configuration for the STM32F4-Discovery board (witht he STM32-DISCO_BB base board).  Verify that the STM32 Ethernet driver works with IPv6.

Add IPv6 support to network driver skeleton and to SAMA5D4 Ethernet driver (which, unfortunately is still missing address filtering logi)

ICMPv6:  Add logic to behave like a router (if so configured):  NuttX will not send the router advertisement message in response to any router solicitation messages.

Networking:  Break out Ethernet definitions into a separate file; add IPv6 multicast addresses as common globals, Ethernet drivers need to filter link-local, all nodes Ethernet address

Re-arrange condition logic from the last change to avoid having STM32-specific conditional logic outside of the STM32 sandbox.

STM32:  Add driver for STM32L162XX AES peripheral. Signed-off-by: Juha Niskanen <juha.niskanen@haltian.com>

Also remove spaces before and after paretheses to conform to coding standard.