MIPS:  Add some build support for the M14K and also for the PIC32MZ Starter Kit.  Still a long way to go

STM32: Fix for compilation introduced by last backup RAM change.  Not sure it it is correct, be now things do compile

Adds the ability to use the STM32F2 and STM32F4 Battery Backedup SRAM in the file system. With an option to Save Panic context to one of the files. From David Sidrane.

Changes to support fully write protecting the backup domain. N.B. stm32_pwr_enablebkp did not account for the delay from enable to the domain being writable. The KISS solution is a up_udelay. A more complex solution would be a negated write test with restore.  From David Sidrane.

Tiva: Move GPIIO prototypes out of arch/arm/include/tiva/irq.h to arch/arm/tiva/tiva_gpio.h where they belong

Fix some time value changes; mostly changing greater than 1000000000 to greater than or equal to 1000000000.  From Juha Niskanen

VFS: The inode unlink method should not be support if operations on the root pseudo-filesystem are disabled.

Tiva: Updated files to allow for ADC triggering by the timer. I’ve cleaned up some parts of the ADC code, too, and fleshed out the PWM triggering ioctl.  From Calvin Maguranis

Break out a new internal interface, stm32_rtc_setdatetime().  This eliminates some un-necessary time conversions.  From Freddie Chopin.

Add a skeleton implementation of the RTC lower half interface at arch/arm/src/stm32/stm32_rtc_lowerhalf.c.  This is just the framework for the RTC lower half.  None of the interface methods have yet been implemetned.

LPC17xx:  Add IPv6 support to the LPC17 Ethernet driver.  Untested... I no longer have a proper environment for LPC17 debug.

SAM4 Ethernet Driver:  No supports operation using the high priority work queue so that packet processing can occur outside of interrupt level processing.

SAM4E-EK: The nsh configuration now configures the Ethernet driver for execution on the HP work thread.

Big, very risky change:  Remove all occurrences of up_maskack_irq() that disable and enable interrupts with up_ack_irq() that only acknowledges the interrupts.  This is only used in interrupt decoding logic.  Also remove the logic that unconditionally re-enables interrupts with the interrupt exits.  This interferes with the drivers ability to control the interrupt state.  This is a necessary, sweeping, global change and unfortunately impossible to test.

SAMA5D Ethernet:  Add support for CONFIG_NET_NOTINTS so that the driver can operate from the work queue thread instead of doing everything from the interrupt level.