- Nov 09, 2015
-
-
Gregory Nutt authored
-
- Nov 08, 2015
-
-
Gregory Nutt authored
-
- Nov 07, 2015
-
-
Gregory Nutt authored
SAMV7 XDMAC: Don't sample interrupt status registers in debug mode. This can cause loss of interrupts
-
Gregory Nutt authored
-
Gregory Nutt authored
-
- Nov 06, 2015
-
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
- Nov 05, 2015
-
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
SAMV7 QSPI: Various kludges added during debug of QSPI. I am not if any of these are really correct
-
Gregory Nutt authored
STM32 ADC: Add support for STM32F30xxx
-
Paul A. Patience authored
-
- Nov 04, 2015
-
-
Frank Benkert authored
-
- Nov 03, 2015
-
-
Gregory Nutt authored
-
- Nov 02, 2015
-
-
Gregory Nutt authored
-
Gregory Nutt authored
-
- Nov 01, 2015
-
-
Gregory Nutt authored
-
Paul A. Patience authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
-
Gregory Nutt authored
pwm duty can by zero
-
pnb authored
-
- Oct 31, 2015
-
-
Gregory Nutt authored
avoid warning unsused function when GPIO_TIMxCHxOUT declared in board and CONFIG_STM32_TIMx not enable but an other CONFIG_STM32_TIMx is enabled
-
Gregory Nutt authored
lpc4337 support: WIP
-
pnb authored
-
pnb authored
avoid warning unsused function when GPIO_TIMxCHxOUT declared in board and CONFIG_STM32_TIMx not enable but an other CONFIG_STM32_TIMx is enabled
-
- Oct 30, 2015
-
-
v01d authored
-
- Oct 22, 2015
-
-
Gregory Nutt authored
Enhance STM32 QEncoder driver with configurable input filters
-
Gregory Nutt authored
Add missing pin definitions on STM32F429, specifically pins available on STM32F429N chip
-
Gregory Nutt authored
Add EXTI definitions for STM32F373
-
Gregory Nutt authored
Add support for STM32F429N (TFBGA) chip
-
Gregory Nutt authored
Fix setup of PLLSAI in STM32F4xx.
-
- Oct 21, 2015
-
-
Marten Svanfeldt authored
Current driver applies a fixed filter of f_sample=f_dts/4, N=6. This can potentially be insufficient in noisy environments, or too slow for really fast encoder sources, so let the user set it from the Kconfig file Signed-off-by: Marten Svanfeldt <marten@intuitiveaerial.com>
-
Marten Svanfeldt authored
Signed-off-by: Marten Svanfeldt <marten@intuitiveaerial.com>
-